OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0625

Lost Communication With Fuel Rail Pressure Sensor Bank 1

Direct-injection engines increasingly use rail pressure sensors that send pressure, and sometimes fuel temperature, digitally via SENT. U0625 says the engine controller has lost this link for the bank 1 sensor. GM's 2025 tables (25OBDG03A) set it when the SENT line stays low with at most four pulses received, in 400 of 500 samples taken every 6.25 ms, Type A; a line stuck high is GM's own code U101B, and corrupted or stale frames are logged as P128F. In 23OBDG07 and 24OBDG07 GM stores U0625 together with U101B when the line sits high or low for 0.5 s, again in one trip, while protocol errors go to U1374. As long as the code is active, GM suspends the fuel temperature checks of the same sensor. The bank 2 sensor has U0665; analog circuit faults are P0190 to P0194. Expect reduced power or hard running.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 25

Possible causes

  • SENT signal wire shorted to ground or to voltage, or open high
  • Fuel or oil contamination, corrosion or loose pins in the sensor connector medium
  • Rail pressure sensor electronics failed (on some engines only with the rail) medium
  • SENT input of the engine controller faulty low

Symptoms

  • Check engine light in the first trip
  • Reduced power, rough running or hard starting
  • Further SENT codes such as U101B stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0625

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication