OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0620

Lost Communication With Exhaust Gas Temperature Sensor Bank 1 Sensor 2

Sensor 2 on bank 1 is the next exhaust temperature measuring point downstream of sensor 1; on diesels it usually sits ahead of the particulate filter or the SCR catalyst, depending on how the maker numbers its sensors. U0620 is the lost-communication code for this point when it is a digital sensor: its frames have stopped, are too old, or its own diagnosis has switched the SENT output off. GM uses it in the same 2025 diesel tables as U061F with an identical rule (19 bad out of 25 samples at 100 ms, Type A), and again a second code identifies the controller input the sensor is connected to. Monitors and regeneration decisions that need this temperature cannot use it while the link is down. An analog sensor at the same position reports circuit faults as P2031 to P2033.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 20

Possible causes

  • Signal, supply or ground wire of the sensor damaged near the exhaust high
  • Moisture or corrosion in the underbody connector medium
  • Sensor electronics module failed medium

Symptoms

  • Malfunction indicator lamp in the first trip on GM diesels
  • Diesel particulate filter or SCR warnings may follow

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0620

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication