OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U061F

Lost Communication With Exhaust Gas Temperature Sensor Bank 1 Sensor 1

Many current exhaust temperature sensors are active: a thermocouple probe, often type N, feeds a small electronics module that turns the reading into SENT or CAN messages, as in the Sensience 22J sensor. U061F means valid messages from the bank 1, position 1 sensor (normally the most upstream one) have stopped. GM's 2025 diesel tables (25OBDG04A and 25OBDG04B) define it for a SENT sensor: any message fault, or messages that are too old, counted in 19 of 25 samples taken every 100 ms once the sensor start-up delay has passed and the engine is not cranking; Type A, so the MIL lights in the first trip. GM also stores a second code tied to the controller input the sensor is wired to. Bentley saw it with U0621 on 2020-on V8 Continental and Flying Spur cars whose harness chafed on a wheel-arch bracket.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 1F

Possible causes

  • Sensor harness rubbing through on a bracket or subframe edge (Bentley V8) high
  • Connector or module of the sensor damaged by exhaust heat medium
  • Internal fault of the active sensor that shuts its SENT output off medium
  • Missing 5 V supply or ground from the controller low

Symptoms

  • Check engine or emission warning lamp
  • Further codes for the controller input or the second bank
  • Particulate filter regeneration may be postponed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U061F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication