Network
generic / SAE
U061E
Lost Communication With Battery Isolation/Voltage Stabilization Control Module
The vehicle bus reports loss of communication with the battery isolation / voltage stabilization module (typical in start/stop systems). Cranking voltage stabilization and second-battery switching cannot be commanded.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 1E
Possible causes
- Bus wiring open or shorted high
- Module without power or ground medium
- Module failed medium
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 120–1200 €
- Estimated time: 0.5–3 h
- Component: battery isolation module
- Component: vehicle bus wiring
- MIL / check engine light
- drive cycle required
Sources
References
sae:J2012