OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0618

Lost Communication With Engine Coolant Bypass Valve D

Bypass valve D is a fourth smart coolant valve and appears only on engines with several separately controlled coolant paths. GM's 2025 table 25OBDG03B is the one public document found that uses U0618: the engine controller polls the valve over LIN and expects its response frame (BRV_Rsp). If that reply is missing for 250 ms or longer while the LIN channel is initialised, the valve is configured as present and the battery has held above 11 V for five seconds, the code fails as Type B and needs two trips to light the MIL. A single silent valve with working neighbours narrows the search to its own branch, connector or electronics; several LIN codes at once point to the shared bus or the master. Coolant flow in that branch may stay at its default position.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 18

Possible causes

  • LIN wire, supply or ground to valve D interrupted or chafed high
  • Poor contact at the valve connector medium
  • Valve D actuator electronics failed medium
  • Fault on the shared LIN bus or in the LIN master (several LIN codes) low

Symptoms

  • Check engine light after two trips
  • Unusual coolant temperature or warm-up behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0618

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication