OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0617

Lost Communication With Engine Coolant Bypass Valve C

Unlike its LIN-based neighbours, GM uses U0617 for a coolant bypass valve whose position sensor transmits SENT frames (SAE J2716) to the engine controller. The tables 25OBDG03B and 25OBDG04B count a failure when the input hardware flags a message fault, when pulses arrive but the newest frame is older than 6.25 ms, or when the SENT pin voltage stays above or below a controller limit while frames go stale. Four failures within a five-second window set the code as Type B over two trips; the 2019 table 19OBDG03D still ran it as Type A after one trip. Suppliers such as Rheinmetall offer coolant valves with SENT position feedback. Typical causes are wiring and connector faults on the three-wire sensor line. The valve may stop being regulated, so warm-up and heater output can suffer.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 17

Possible causes

  • SENT signal, 5 V supply or ground wire of the valve position sensor open or shorted high
  • Corroded or loose connector at the valve medium
  • Position sensor inside the valve failed (usually replaced with the valve) medium
  • SENT input of the engine controller faulty low

Symptoms

  • Check engine light (on GM after two trips, on 2019 calibrations after one)
  • Slow warm-up or reduced heater output
  • Possibly further coolant valve codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0617

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication