OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0614

Lost Communication With Intake Air Temperature Sensor 2 Bank 2

This is the bank 2 counterpart of U0613: the downstream intake temperature sensor of the second bank, usually after that bank's charge air cooler or in its manifold half, delivers its value digitally and the controller has stopped receiving it. Typical carriers are TMAP-style sensors whose SENT frames hold pressure and temperature, protected by a CRC and status bits, as described for Infineon's KP276. No manufacturer documents U0614 publicly; even GM's twin-throttle tables, which use U0611 to U0613, leave it out. The code therefore rests on CARB 1968.2, which demands a separate fault code when a digital input stops communicating. P00A5 to P00A9 describe the analog circuit of the same sensor. The engine controller falls back to a modelled charge temperature for that bank.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 14

Possible causes

  • Wiring fault to the bank 2 combined temperature/pressure sensor high
  • Bank 2 combined sensor failed medium
  • Corroded or oily connector at the bank 2 sensor low

Symptoms

  • Check engine light
  • Little effect on driving, occasionally less boost

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0614

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication