U0613
Lost Communication With Intake Air Temperature Sensor 2 Bank 1
Intake air temperature sensor 2 sits further downstream than sensor 1, for example after the charge air cooler or in the manifold, where it is frequently combined with a pressure sensor (a TMAP unit). Digital versions send the temperature together with pressure; Melexis' MLX90818 can carry a medium temperature in its SENT frame and replaces the value with a reserved error code when measurement fails. U0613 means this digitally delivered temperature for bank 1 is no longer received. The only public manufacturer use is GM (23OBDG07/24OBDG07), whose dual-throttle calibration stores U0613 jointly with U0611 when the bank 1 temperature message is lost or stuck high or low, MIL after two trips. P0095 to P0099 are the analog codes. Charge temperature then runs on a substitute value.
Possible causes
- Damaged wiring to the combined temperature/pressure sensor high
- Temperature element or electronics of the combined sensor failed medium
- Oil from the charge air path in the connector low
Symptoms
- Check engine light, on GM after two trips
- Possible spark retard or boost reduction as a precaution
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0613
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.