OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0611

Lost Communication With Intake Air Temperature Sensor 1 Bank 1

Intake air temperature is often no longer a separate NTC wire to the controller but a value inside a digital frame: combined air flow meters send it over LIN or SENT, and pressure chips such as Infineon's KP276 digitize an attached NTC and pass it on in the same SENT message. U0611 concerns sensor 1 of bank 1, typically the upstream sensor in the air filter or air flow path. GM documents it for a two-throttle calibration of 2023/2024, paired with U0613: it sets when the temperature message from the sensor upstream of throttle 1 stops arriving or its line reads as stuck high or stuck low; the MIL comes on after two trips. P0110 to P0114 are the analog circuit codes. Fuel and spark corrections then use a fixed substitute temperature.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 11

Possible causes

  • Wiring fault to the combined sensor that carries the temperature value high
  • Electronics of the combined air flow or pressure sensor failed medium
  • Corroded or loose connector in the intake path medium

Symptoms

  • Check engine light, on GM after two trips
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for U0611

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication