U060F
Lost Communication With Mass or Volume Air Flow Sensor A
Modern hot-film air flow meters often transmit digitally; Bosch lists SENT, frequency and LIN outputs, and many units also carry pressure, temperature or humidity. U060F means sensor A's messages are missing. GM's 2025 tables run it on LIN: no answer to the pressure request for at least 62.5 ms or to the temperature/humidity request for 250 ms, Type A or B by calibration. GM bulletin 24-NA-158 traces P0102 with U060F on 2023/2024 full-size SUVs with L84/L87 V8 engines to water that got into the sensor connector during assembly and replaces sensor and connector. Mitsubishi's 2023 Outlander PHEV sets U060F-00 after a 2 s SENT timeout or data error and then estimates air mass from throttle opening. Ford uses it for SENT units too.
Possible causes
- Water, corrosion or loose terminals in the air flow sensor connector high
- LIN or SENT line, battery feed or ground to the sensor interrupted medium
- Air flow sensor electronics failed medium
- Sporadic communication error without hardware fault (cleared and rechecked) low
Symptoms
- Check engine light, often together with an air flow circuit code
- Engine runs on a modelled air mass, with reduced response
- Rough idle or hesitation
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U060F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.