OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U060E

Lost Communication With Crankcase Pressure Sensor

A crankcase pressure sensor lets the engine controller check the positive crankcase ventilation for leaks or a disconnected hose, which CARB 1968.2 requires. Ford fits it in two versions. The analog one reports circuit low, high and range faults; the SENT one uses P051A and U060E. Ford's gasoline summaries for 2020 to 2023 and 2024 run this check continuously and record a fault after 5 s once the controller recognizes faulted signal patterns from the sensor; P051A then marks a sensor that reports itself defective, U060E a link that no longer delivers usable frames. Both block the ventilation disconnect test (P04DB, later P2C90), because that monitor needs a working sensor. Drivability is normally unaffected, but the MIL comes on.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 0E

Possible causes

  • Damaged SENT, supply or ground wire to the crankcase pressure sensor high
  • Oil or moisture in the sensor connector medium
  • Crankcase pressure sensor electronics failed medium

Symptoms

  • Check engine light
  • Crankcase ventilation monitor does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U060E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication