U060D
Lost Communication With Turbocharger/Supercharger Boost Sensor C
A third boost sensor C appears only on complex charging layouts, for instance sequential or two-stage turbo systems with pressure taps between and after the stages, or engines that add an electric compressor. U060D reports that the controller has lost the digital link to this sensor: no SENT frame inside the expected time, a frame failing its check, or a sensor that transmits only its reserved error value, a feature found on pressure chips such as Melexis' MLX90818. No manufacturer documents U060D publicly, so its use rests on the CARB 1968.2 requirement and the pattern of U060B. Which physical sensor is called C is a manufacturer decision. P25F2 to P25F5 cover the analog circuit of the same sensor. Expect boost to be limited on the affected stage.
Possible causes
- Open or shorted SENT, supply or ground wire to sensor C high
- Sensor C sending only its error value medium
- Corroded connector at sensor C low
Symptoms
- Check engine light
- Power loss when the affected stage would build boost
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U060D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.