U060B
Lost Communication With Turbocharger/Supercharger Boost Sensor A
Boost sensor A measures charge air pressure after the compressor and is often a SENT pressure sensor with built-in temperature measurement. U060B means the engine controller no longer hears from it. Audi documents the code for the 2022 to 2025 Q5 and SQ5 family (bulletin 2074392): the MIL comes on and the engine control unit stores U060B00 against G31, the boost pressure sender, either intermittent or static. Engine vibration can break the three wires right at the sender connector, which may only show once the terminals are unpinned or the tape is removed; the fix is a new pigtail with set lengths, and production changed from January 2025. P0235 to P0238 cover an analog sensor's circuit faults. Boost control falls back to a safe low level.
Possible causes
- Wires broken by vibration right behind the sensor connector high
- Boost sensor electronics failed medium
- Loose terminal or oil in the connector medium
Symptoms
- Check engine light
- Noticeably less power, boost held low
- Fault may come and go with engine vibration
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U060B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.