U0606
Lost Communication With Throttle/Pedal Position Sensor/Switch A
Many electronic throttle bodies now report the blade angle as digital SENT frames (SAE J2716) instead of two analog voltages. U0606 means the engine controller no longer receives valid frames from position sensor A. Ford's gasoline summaries for 2020 to 2024 use it on SENT throttle bodies: a wiring fault or a faulted SENT device lasting over 4 s lights the MIL and the wrench lamp, while a line shorted low or high gets separate codes and P0120 covers a sensor that still talks but flags itself faulty. GM's 2025 tables (25OBDG03A) name it throttle position sensor 1 and fail it as Type A for line levels under 0.5 V or over 4.1 V, wrong pulse timing, stale messages or CRC errors. Throttle authority is then cut back.
Possible causes
- SENT signal, 5 V supply or ground wire to the throttle body open, shorted or chafed high
- Loose, corroded or water-soaked throttle body connector medium
- Sensor electronics in the throttle body failed (replacement usually as a complete throttle body) medium
- Engine controller SENT input or software fault low
Symptoms
- Check engine light, on Ford also the wrench lamp
- Reduced power or limp mode with limited throttle response
- Rough or unstable idle
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0606
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.