U05C0
Invalid Data Received From Interior Lighting Control Module B
Cars with extensive ambient and cabin lighting split it across several controllers; module B is the second of these, for instance for the rear cabin, the doors or a separate light strip, while A runs the main zone. These nodes usually hang on a LIN line below the body controller, which sends them colour and brightness commands and polls their status; Microchip's reference design runs this at about 10.4 kbit/s with a checksum on every frame. U05C0 is set when status replies from module B arrive but are corrupt or implausible, as opposed to U02BF, where B stops replying. No manufacturer documents U05C0 or the allocation of letter B. Expect zones that stay dark or show the wrong colour, while the main interior lights controlled by module A (U054B) keep working.
Possible causes
- LED controller of lighting module B defective medium
- LIN line or connector to module B damaged, for example in a door hinge area medium
- Replacement module B not configured for its zone low
Symptoms
- Ambient light zone stays dark or flickers
- Wrong colour or brightness in part of the cabin
- Lighting settings in the menu not applied to all zones
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U05C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.