OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U05B8

Invalid Data Received From Rear Radar Module B

Module B is the right-hand rear corner radar in the only public manufacturer use: Mercedes-Benz lists U05B855 for the outer right rear sensor of the 2026 CLA electric. The fault type 55 reads as not configured, so the content is rejected because the controller N62/5 has no valid setup for that sensor, not because the radar is broken. The May 2026 version of bulletin LI54.71-P-080345 narrows the case to cars built before 27 February 2026 with persistent warnings and drops the hardware reset step of version 1; afterwards the car must sleep for seven minutes, and full assistance returns after roughly ten more minutes of driving. Replacing the sensor is therefore rarely the first step. Right-side blind spot and cross traffic warnings fail. U02B7 means module B is silent.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / B8

Possible causes

  • Right rear radar not configured, calibration of the assistance controller missing high
  • Initial calibration of the controller's acceleration sensor not completed medium
  • Right rear radar internally defective low

Symptoms

  • Blind spot indicator on the right stays off
  • Assistance warnings reappear on every start
  • Rear cross traffic alert missing on the right

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U05B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication