OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U05A9

NOx Sensor C Received Invalid Data From ECM/PCM

With this code the third NOx sensor, fitted after a second SCR stage, reports that it cannot use the frames the engine controller sends it, such as heater release or operating state. No manufacturer documents U05A9 publicly. The closest published logic is Ford's 2023 diesel summary for sensors A and B (U05A1, U05A2): bad input is flagged when a dew point release comes while the key is off or when frames pause longer than 1 s, and the fault is logged after 5 s. GM's 25OBDG04B shows that a sensor C exists, but only for the opposite direction (U05A8). CARB 1968.2 requires communication errors on digital outputs to be detected. If the sensor never gets its heating release, its readings and the second-stage SCR check stay unavailable.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / A9

Possible causes

  • Intermittent bus connection to sensor C medium
  • Engine controller not configured for the third sensor medium
  • Sensor C control unit rejecting valid data low

Symptoms

  • Check engine light on
  • No NOx value from sensor C on the scan tool

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U05A9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication