U05A7
Invalid Data Received From Safety Integration Control Module
The Safety Integration Control Module appears in the SAE code catalogue, yet no carmaker explains in public what this unit does or which models carry it; the name suggests a controller that ties several safety functions together. U05A7 is stored by a receiving module that still gets the unit's frames but refuses what they contain. Safety-related signals are normally secured end to end: the AUTOSAR E2E protocol attaches a CRC to detect altered bits, a counter to spot repeated or reordered frames and a data ID so that a wrong sender is recognised. Failing one of these checks is the typical trigger. No manufacturer documents U05A7 or its partner U02A6, which stands for a module that has gone silent. Expect warnings and reduced assistance, not an emissions fault.
Possible causes
- Software fault or outdated software in the safety integration module medium
- Module replaced or reprogrammed without matching vehicle configuration medium
- Corrupted frames from wiring, connector or termination faults on the bus low
- Low supply voltage during start or after battery discharge low
Symptoms
- Warning message about safety or assistance systems
- Individual assistance functions unavailable
- Further network codes stored in several modules
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U05A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.