U05A5
Invalid Data Received From NH3 Sensor
An ammonia (NH3) sensor behind the SCR catalyst tells the controller whether too much urea is dosed and ammonia slips through. Like NOx sensors it carries its own electronics and talks over CAN; Bosch even offers NOx sensors that add a selective ammonia signal. U05A5 means the ammonia data come in but fail validation. FCA's bulletin 18-028-16 for 2014 Ram 3500 to 5500 Cab Chassis with the 6.7 L Cummins shows a special case: two ECM calibrations exist, with and without the ammonia sensor, and if U05A5 or U12A4 appears after the update, the wrong one was loaded. CARB 1968.2 requires a monitoring plan for such other exhaust gas sensors. U02A4 means the sensor is silent. Dosing control loses its slip feedback.
Possible causes
- Engine calibration does not match the sensor fit (with or without NH3 sensor) high
- Ammonia sensor control unit faulty medium
- Damaged wiring or connector at the ammonia sensor low
Symptoms
- Check engine light on
- Code appears right after an engine software update
- SCR dosing runs without ammonia feedback
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U05A5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.