OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U05A2

NOx Sensor B Received Invalid Data From ECM/PCM

This is the downstream counterpart of U05A1: the tailpipe NOx sensor B finds the frames it gets from the engine controller missing or implausible and reports it. Ford's 2023 diesel summary documents it for the 3.0 L and 6.7 L engines next to P229E in the tailpipe NOx controller checks, using the same criteria as for the front sensor, an erroneous signal such as a dew point release with ignition off, or more than 1 s without a message, confirmed after 5 s. Ford's 2014 list also shows it with MIL. Because sensor B measures what leaves the SCR catalyst, the efficiency monitor cannot finish while the code is active. U059F describes the reverse problem, U029E a sensor that has gone quiet. A software update or bus repair usually comes before replacing the sensor.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / A2

Possible causes

  • Damaged harness to the rear sensor, exposed to road spray and heat medium
  • Engine controller software sending implausible commands medium
  • Fault inside the sensor B control unit low

Symptoms

  • Check engine light on
  • SCR efficiency monitor incomplete

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U05A2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication