U05A1
NOx Sensor A Received Invalid Data From ECM/PCM
Here the fault is judged inside NOx sensor A: its control unit relies on engine controller frames, for instance the release to heat the probe once condensation is no longer a risk, and it reports back when those inputs are missing or make no sense. Ford's 2023 diesel OBD summary groups U05A1 with P2200 under the upstream NOx module checks. Typical triggers are a dew point release received while the ignition is off, or no message for more than 1 s; 5 s of fault are needed to register it. Ford's 2014 code list flags it as a MIL code. CARB 1968.2 asks that digital outputs to a component be checked for communication errors. U059E is the opposite direction, U05A2 and U05A9 cover sensors B and C. The probe may stay cold, leaving NOx readings and SCR monitoring unavailable.
Possible causes
- Engine controller software or configuration sending wrong values to the sensor medium
- Intermittent CAN connection to the sensor causing timeouts medium
- Sensor control unit misjudging correct data medium
Symptoms
- Check engine light on
- NOx reading for sensor A stays invalid on the scan tool
- SCR monitors not completing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U05A1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.