OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U05A0

Invalid Data Received From Evaporative Emission System Leak Detection Control Module

Some fuel systems hand the tank leak test to a separate module with its own pump, valve, pressure sensor and processor. Stoneridge patent US11773809 describes such a unit: it wakes hours after shutdown while the engine controller sleeps, runs the test alone and later passes pressure results over CAN or LIN, from which the OBD system decides on a fault code. U05A0 is set when those reports arrive but cannot be trusted, for example wrong length, counter or values. Ford's 2014 OBD code list shows it with the lamp indicator. CARB 1968.2 requires leak detection down to 0.020 inch on gasoline vehicles, so a module whose data are rejected leaves the EVAP readiness open. U029F means no messages at all, U030A a software mismatch. Driving is unaffected.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / A0

Possible causes

  • Leak detection module electronics or its pressure sensor failing medium
  • Corrosion at the module connector near the tank or canister medium
  • Module and engine controller software levels do not match low

Symptoms

  • Check engine light on
  • EVAP readiness not set, emissions inspection may fail

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U05A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication