U059E
Invalid Data Received From NOx Sensor A
NOx sensor A usually sits upstream of the SCR catalyst. Its attached electronics turn the probe current into NOx and oxygen readings and broadcast them on CAN. Here those frames still arrive, yet the receiver rejects them. GM's 2025 diesel ECM tables (25OBDG04A/B) count wrong alive rolling counts, protection values or checksums: 8 bad out of 18 samples for most signals, 3 out of 10 for a few, with at least 11 V present for 5 s. It is Type B, so the MIL follows on the second trip. Ford's 2023 diesel summary sets it when the sensor's calibration verification number never reaches the ECU. U029D stands for a silent sensor, U05A1 for the reverse path. Until valid readings return, NOx-based SCR checks and dosing feedback cannot run.
Possible causes
- Sensor control unit of NOx sensor A faulty (heat, moisture, internal error) high
- Replacement sensor of a different part number or software level medium
- Corroded connector or damaged CAN/supply wiring at the sensor medium
- Engine controller software needing an update low
Symptoms
- Check engine light after the second faulty trip
- SCR and NOx sensor monitors stay incomplete
- Engine usually runs normally
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U059E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.