OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U059C

Invalid Data Received From Drive Motor Control Module C

A third drive motor controller exists only on tri-motor or quad-motor vehicles, where one axle carries two motors for torque vectoring. Examples are GMC's Hummer EV in tri-motor form and Rivian's quad-motor R1T with a motor at each wheel. U059C is stored when module C still talks but sends torque, speed or status values the vehicle controller cannot accept. Which wheel or axle module C serves is left to the maker, and none documents U059C publicly. The sibling logic is the same as for module B, which Audi treats as the rear drive unit on the e-tron and GM monitors with counter and authentication checks; for C the vehicle usually disables the motor and continues with reduced power and without torque vectoring on that axle.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / 9C

Possible causes

  • Inverter or controller of motor C faulty medium
  • Low-voltage harness or connector at drive unit C damaged medium
  • Software level of motor C not matching the vehicle controller medium

Symptoms

  • Propulsion system warning and reduced power
  • Torque vectoring or a drive mode unavailable

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U059C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication