U059B
Invalid Data Received From Hybrid/EV Battery Pack Sensor Module
The battery pack sensor module measures pack voltage and current and often sits in the switch box that holds the main contactors, reporting to the battery management controller. Audi uses U059B00 for an implausible signal from the high-voltage battery switch box on the 2024 Q8 e-tron family: after a stop at an AC charging point the car refused to enable its drive and the cluster asked the driver to stop safely, with contactor control codes P0ADC00 and P0AE000 stored alongside. Audi traced it to over-sensitive diagnostic software, advised a 20-minute bus sleep before towing and ruled out replacing parts. The 2025 Q5 e-tron shows U059B00 together with lost contact U029A00 (index entry only). CARB requires battery system faults that stop the pack moving the vehicle to be detected.
Possible causes
- Over-sensitive battery management software (Audi 2073482) high
- Current or voltage sensing in the switch box faulty medium
- Battery-internal communication line or connector disturbed low
Symptoms
- Drive system cannot be activated
- Drive system and electrical system fault messages
- Charging interrupted
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U059B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.