U0572
Invalid Data Received From Vehicle Motion Control Module A
A vehicle motion control module sits above the individual chassis controllers and coordinates steering, brakes, damping and drive torque. ZF's cubiX software works this way and went into production in the Lotus Eletre; Hitachi Astemo describes a central controller that sends time-referenced instructions to several actuator modules. U0572 means that one of these actuator controllers or the gateway receives such instructions or status data from module A but finds them invalid, for example out of range or with a broken counter or checksum. No manufacturer documents U0572 publicly, and there is no generic lost-communication code for this module. The receiving controllers then ignore the commands and fall back to their own functions.
Possible causes
- Software of motion control module and chassis controllers not matched high
- Motion control module A internally faulty medium
- Implausible sensor input to the module (yaw, steering angle) leading to invalid outputs medium
- Disturbed chassis network or gateway low
Symptoms
- Chassis or stability warning message
- Rear-axle steering, active roll control or drive modes switched off
- Car drives with basic stability control only
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0572
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.