U056A
Invalid Data Received From Image Processing Sensor E
U056A is the invalid-data code for image processing sensor E: the module still talks, but the receiver rejects what it says. No brand documents U056A itself. GM lists the partner U0269 among codes held by the active safety controller of many 2013–2018 models with driver-assist packages, among them Escalade, ATS, CT6, Malibu, Volt and Acadia. These sensors share a separate object detection bus, wired to pins 3 and 11 of the diagnostic connector. GM warned that a worn scan-tool interface or cable on exactly those pins produces false U-codes and blocks contact with the radars and front camera; a loopback adapter or a known-good vehicle proves the tool. Rule out the tester before chasing sensor E. No MIL.
Possible causes
- Faulty diagnostic interface or cable on the object detection bus pins (false codes) medium
- Fault on the dedicated object detection bus wiring medium
- Sensor E software fault or internal defect low
Symptoms
- Object detection or Service Active Safety message
- Scan tool cannot reach radars and front camera
- Code returns only when one particular tester is connected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U056A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.