OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U055B

Invalid Data Received From Special Purpose Vehicle Control Module B

U055B concerns the second slot reserved for special purpose controllers. A receiving module gets frames from controller B, but a signal lies outside its permitted span, a counter or checksum is wrong, or the frame length does not match. No manufacturer documents U055B publicly. How freely these slots are filled shows in Deutz's engine controller for off-highway machines, which reports a timeout of its tractor-trailer bridge under U0259, the lost-communication code of slot A. On road vehicles slot B mainly matters when a conversion carries more than one add-on controller, for example separate units for warning lights and for body hydraulics. U025A is the lost-communication counterpart. Only the conversion equipment is normally affected.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number5 / 5B

Possible causes

  • Second add-on controller set up with wrong address or message set high
  • Software of add-on controller B and vehicle modules not matched medium
  • Unstable supply or ground at controller B, e.g. on a shared accessory feed medium
  • Controller B internally faulty low

Symptoms

  • One group of conversion functions fails while others still work
  • Fault entry in the receiving module, usually without warning lamp

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U055B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication