U0555
Invalid Data Received From Remote Start Module
A remote start module lets the engine run from a key fob or app for heating or cooling and must work around the immobilizer while doing so; it may be a factory part, a dealer accessory or an aftermarket box tied into the CAN network. GM lists the remote start module as its own node (Saab 9-5 2011: U0254). Subaru shows how a mismatch in the interface between gateway and its accessory Remote Engine Starter set U0254 on the 2020 Legacy/Outback without any effect on function, cured by revised modules (15-258-19R). Mercedes warns that aftermarket remote start and other CAN devices on Sprinter and Metris can cause communication faults and failed programming. U0555 means frames come in but are invalid; U0254 means none arrive. No bulletin names U0555. Remote start may fail or nothing is noticeable.
Possible causes
- Aftermarket remote starter or other add-on device on the CAN bus sending non-conforming messages high
- Software of the remote start module not matching the vehicle gateway medium
- Poor splices or connectors from the remote starter installation medium
Symptoms
- Engine does not start or shuts down again when started remotely
- Code found during an all-systems scan with no noticeable fault
- Module programming at the workshop does not complete
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0555
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.