U0541
Invalid Data Received From Entrapment Control Module B
Entrapment control module B is the second slot for a separate pinch-protection unit. Some designs detect a person before contact: a capacitive strip changes its electric field as a hand approaches, and the attached electronics pass the result to the closure controller either as a switched output or as LIN or SAE J2602 data, as a review of tailgate anti-pinch approaches explains; patent US20030151382 likewise combines a capacitive field with a position sensor. U0541 is stored when frames from such a unit B are malformed or implausible. No manufacturer publishes the code. FCA's case S2208000106 shows how confusing two-sided sensing can be: its left and right liftgate pinch sensor codes may point to the wrong side, so check both connectors. U0240 covers complete loss of module B.
Possible causes
- Capacitive sensor strip or its electronics delivering implausible values medium
- Sensor connector not fully seated or corroded medium
- Software or calibration of module B not matching after replacement low
Symptoms
- Power liftgate or sliding door stops or reverses without contact
- Automatic closing refused with a warning
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0541
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.