U053A
Invalid Data Received From Entrapment Control Module A
Entrapment control modules handle pinch protection for powered closures where it is not built into the drive, typically sliding doors, liftgates or roofs with sensing edges. For windows, roof panels and partitions FMVSS 118 sets the goal: stop and reverse before 100 N act on the test rod. Chinese patent CN102923068B shows a dedicated anti-pinch module for a back door that drives the motor, reads a Hall sensor and exchanges commands and diagnostic messages with the body controller over CAN. U053A means such a module A is transmitting, but its data are rejected. No manufacturer documents the code or what module A protects. Expect the affected closure to refuse automatic closing or to reverse unexpectedly; U0239 is the lost-communication counterpart.
Possible causes
- Entrapment control module A internally faulty or with wrong software medium
- Damaged pinch sensor edge feeding implausible values into the module medium
- Bus wiring to the module damaged, e.g. in a liftgate or door hinge low
Symptoms
- Power closure will not close automatically
- Closure reverses without an obstacle
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U053A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.