U0537
Invalid Data Received From Column Lock Module
The column lock module drives the electric bolt that blocks the steering shaft when the car is parked and frees it before the engine may start. U0537 records that a partner module, such as the body controller or keyless start unit, received lock status messages it cannot trust. No manufacturer explains this exact code publicly. Related bulletins show how tightly the lock depends on timing and authentication: GM bulletin 16-NA-091 (ATS, CTS, XTS) reprogrammed the module after a Service Column Lock message with B2897, caused by door and power-mode changes within 100 to 300 ms, and Stellantis case S2408000110 (Wrangler 2024) lists implausible ignition, speed and coded BCM messages seen by the lock itself, with 10 to 16 V required. Possible effects: no start, column stays locked or a warning. U0236 is the lost-communication code.
Possible causes
- Column lock module software or calibration fault (reprogramming) high
- Weak 12 V battery or voltage drops during start medium
- Lock module not paired/learned to the body or immobilizer module after replacement medium
- Mechanical or internal fault of the lock actuator low
Symptoms
- Engine does not start or start is refused
- Steering wheel remains locked
- Steering column lock service message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0537
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.