U0532
Invalid Data Received From Rain Sensing Module
The rain sensing module behind the windshield measures how much infrared light wet glass scatters and, in most designs, also reads ambient light for automatic headlamps. Melexis describes such a unit as an optical front end, a microcontroller and a LIN system basis chip linking it to the body controller. U0532 is logged when that controller or a gateway receives the module's frames but rejects them, for example an impossible rain intensity, a parity or checksum error or a response of the wrong length. Jeep shows the related loss case: on the 2021 Grand Cherokee (WL) the body controller could store U0231-00 for the LIN rain sensing module without a MIL, corrected by a BCM flash (08-050-22, with sister bulletins for Wagoneer and 4xe). With bad data, automatic wipers fall back to manual or run at odd intervals.
Possible causes
- Rain and light sensor electronics faulty medium
- Sensor badly coupled to the glass or wrong variant after windshield replacement medium
- Corroded connector or chafed LIN wire at the windshield headliner medium
- Body controller software evaluating the sensor frames incorrectly low
Symptoms
- Automatic wipers do not react to rain or wipe on a dry screen
- Automatic headlamps switch late, early or not at all
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0532
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.