U0525
Invalid Data Received From Door Window Motor C
Data from window motor C include what the door controller needs for automatic closing, which in the United States falls under FMVSS 118. A window able to close without the switch being held must stop and reverse before it presses on a test rod of 4 to 200 mm with 100 N or more, and then open again by at least 125 mm or far enough for a 200 mm rod. If the reports from motor C are corrupt, the controller can no longer rely on that reversal, so a cautious design blocks one-touch and remote closing for this window. No manufacturer documents U0525 or names the door behind C. Raising and lowering with the switch held usually still works; U0224 is the lost-communication partner.
Possible causes
- Motor C electronics sending corrupted status medium
- Voltage drop at the motor during start-up (weak battery, poor ground) medium
- Chafed LIN wire in the door harness low
Symptoms
- Automatic closing on locking does not close this window
- Window only operable with the switch held
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0525
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.