U0524
Invalid Data Received From Door Window Motor B
U0524 means the master accepts frames from window motor B but not what they say. A common reason is a position value the controller cannot reconcile. Smart lift motors count Hall pulses between a learned lower and upper end, and Atmel's anti-pinch application note AVR480 describes acquiring such parameters during initialisation and spotting a defective Hall sensor from a run of apparent direction changes. After a battery disconnection, a motor replacement or a regulator that has slipped, the stored travel no longer matches reality, and many systems fall back to manual operation until the window has been re-initialised. No manufacturer publishes setting criteria for U0524 or the door assigned to B. U0223 covers a motor that has stopped answering.
Possible causes
- End positions lost after battery disconnection, motor or regulator work high
- Hall sensor in motor B faulty, giving erratic position counts medium
- Regulator cable or glass clamp slipped, so travel no longer matches low
Symptoms
- One-touch operation lost on that window
- Window stops short of the top or reverses near the seal
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0524
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.