U0518
Invalid Data Received From Door Switch C
U0518 is set when a receiving controller gets data from door switch unit C that it cannot trust. Which door that is remains unpublished, and no manufacturer documents the code. Door switch packs are usually LIN slaves, and LIN protects every frame with a parity-checked identifier and a checksum; NXP's keypad design even reports bit, checksum, parity and no-response errors back in its status bytes. A cracked wire in the flexing harness between body and door, a weak ground or voltage dips while window motors start can therefore corrupt frames without silencing the unit, which would instead give U0217. The effect stays limited to whatever switch C commands: windows, locks or mirrors may ignore it. Inspect the hinge-area harness before replacing the switch.
Possible causes
- Partly broken data or ground wire in the door hinge area high
- Supply dips while motors start (weak battery, poor ground) medium
- Switch unit C internally faulty medium
Symptoms
- Controls on one door respond only sometimes
- Fault appears when the door is opened or closed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0518
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.