U0501
Invalid Data Received From Door Control Module B
Many cars give each door its own electronics: a door unit receives commands over CAN and drives window lift, lock and mirror, as a Yazaki patent describes with a LIN sub-bus inside the door. Module A has its invalid-data code in U049A; U0501 is the same check for the second door unit. The body controller or another listener gets B's frames, for instance lock status, window position or switch inputs, but finds them implausible, out of sequence or with a bad checksum. Which door B serves is not standardised, and no carmaker documents U0501 publicly. GM's Saab 9-5 list, for one, has no partner entry U0200 for it. Silence from B gives U0200. The driver may notice one door that no longer locks centrally or whose window switch is ignored.
Possible causes
- Water ingress into the door module through a failed door membrane medium
- Broken wires in the harness grommet between body and door medium
- Door module not programmed or configured after replacement medium
Symptoms
- One door not following central locking
- Window, mirror or door-ajar display of that door erratic
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0501
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.