U04BC
Invalid Data Received From Switch Input Module C
With a third switch input module, addressing becomes a weak point. Several near-identical switch units often hang on one LIN line as slaves, and each needs its own node address, assigned either by part variant or by an auto-addressing routine at start-up. If two units end up with the same address, or a reply arrives with a bad LIN checksum, the master receives data it cannot assign and the controller records U04BC for module C. Nothing public ties this code to a specific make or to a fixed location in the car. U01B9 covers the case where module C does not answer at all, and U04BD, which follows in the list, belongs to the park lock module rather than to this series. Effects stay limited to the buttons wired to module C.
Possible causes
- Two switch units with the same LIN node address after replacement or failed auto-addressing medium
- Switch input module C internally faulty medium
- Interference on the shared LIN line, e.g. damaged insulation low
Symptoms
- Buttons of module C ignored while other switch groups work
- Button presses assigned to the wrong function
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U04BC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.