U04BA
Invalid Data Received From Switch Input Module A
A switch input module collects the positions of several buttons and reports them to other control units as network frames. U04BA means that frames from module A keep arriving, but the receiver, usually the body controller, rejects their content: a switch state outside the defined values, a wrong message counter, a failed checksum or an unexpected length. An Eaton patent describes such a module in which a controller polls each switch address and acts only on replies carrying a valid address and state. Which buttons belong to module A is up to the carmaker; no maker documents this code publicly. If module A falls silent, U01B7 is set instead. For the driver, the buttons handled by this module may do nothing or trigger the wrong function.
Possible causes
- Switch module or receiving controller with incompatible software or coding after repair medium
- Switch input module A internally faulty (moisture, damaged switch contacts) medium
- Corroded connector or chafed data lead corrupting the frames low
Symptoms
- Buttons served by the module inoperative or acting intermittently
- Code stored in the body controller without a warning lamp
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U04BA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.