OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U04B6

Invalid Data Received From Catalyst Heater Control Module

An electrically heated catalyst brings the converter to working temperature right after a cold start. Vitesco's EMICAT heater runs at 12, 24 or 48 V and can draw up to 300 A, has been ordered for 48-volt mild hybrid diesel vans with production planned from 2022, and in high-voltage hybrids is fed by a dedicated DC/DC converter. The electronics that switch this power report heater state and energy to the engine controller. U04B6 is stored when those messages arrive but fail plausibility; no carmaker has published its use of the code. Section (e)(2) of CARB 1968.2 requires OBD to confirm that a heated catalyst reaches its target temperature in time, so the check cannot run without valid data. U01B5 marks lost contact. Expect a MIL and higher cold-start emissions.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / B6

Possible causes

  • Heater control electronics or DC/DC stage faulty medium
  • High-current connection to the heater loose or overheated, giving implausible feedback medium
  • Bus wiring or connector near the hot exhaust damaged medium
  • Module and engine controller software not matching low

Symptoms

  • Check engine light on
  • Catalyst monitor readiness not set
  • Engine may idle longer at raised speed after cold start

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U04B6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication