OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U04B1

Invalid Data Received From Battery Monitor Module

Despite its place after the high-voltage interface series, U04B1 usually concerns the 12 V side: in GM's 2024 OBD table 24OBDG07 the battery monitor module is the intelligent battery sensor on the 12 V battery, read by the body control module over LIN. GM sets U04B1 when the alive rolling counts of the sensor's signals, among them charged and discharged amp-hours, state of charge, temperature and crank data, are wrong in 8 of 10 samples, polled every 250 ms, with the car in run, above 11 V and at least 5 s after power-up; Type B, two trips. Alfa Romeo reported U04B1-00 in the PCM of 2017–2019 Giulia and Stelvio after a module flash and cleared it with a BCM configuration restore. U01B0 means the sensor is silent.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / B1

Possible causes

  • Body control module configuration lost or mismatched after reprogramming (Alfa Romeo) high
  • Intelligent battery sensor on the negative terminal faulty medium
  • LIN lead or plug at the battery sensor damaged or corroded medium

Symptoms

  • Check engine light (GM Type B, after two trips)
  • Start-stop disabled or charging strategy of the generator changed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U04B1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication