U04AF
Invalid Data Received From Hybrid/EV Battery Interface Control Module O
U04AF concerns interface module O, the fifteenth board. In practice a data fault of this kind often follows work on the pack: if a replaced board and the battery controller interpret messages differently, frames arrive formally intact but fail range or counter checks. The software sibling U0348 and a search for available updates therefore belong next to this code, as does U01AE for a module that stopped sending. GM's 2015 note PIC6080 for the 2011–2014 Volt, ELR and Ampera says to reprogram the battery and hybrid controllers first when cell codes are spread over several pack sections, and to call technical assistance only when all of them sit on one interface board. No maker documents U04AF; the letter O only exists on very large packs.
Possible causes
- Software levels of replaced board and battery controller do not match high
- Interface control module O faulty medium
- Plug not fully seated after pack repair low
Symptoms
- Battery warning shortly after a battery repair
- Reduced power or charging
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U04AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.