Network
generic / SAE
U04AA
Invalid Data Received From Hybrid/EV Battery Interface Control Module J
A receiving module detected implausible data from hybrid/EV battery interface module J. Cell-voltage, current or temperature values fail plausibility checks against other inputs and are rejected.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / AA
Possible causes
- Module internal fault or sensor input drift high
- Software version mismatch after replacement medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 200–2500 €
- Estimated time: 1–5 h
- Component: hv battery interface module j
- MIL / check engine light
- drive cycle required
- limp mode possible
Sources
References
sae:J2012