OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U04A6

Invalid Data Received From Hybrid/EV Battery Interface Control Module F

U04A6 is set when interface control module F delivers messages the battery controller cannot accept. A board like this checks itself as well: in GM's 16OBDG02 table every interface module, F included, runs four processor performance tests once at each ignition change, for example confirming that its analogue-to-digital converter shows no stuck bits when the input is forced to its limits, Type A after 8 failures in 10 samples. Such internal faults get their own GM P1 codes; U04A6 is meant for the case where the receiver itself judges the incoming data unusable. No manufacturer documents U04A6 publicly. U01A5 means F has stopped talking, U033F that its software does not fit. Expect a hybrid or EV warning and restricted output.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / A6

Possible causes

  • Processor or converter fault on interface board F medium
  • Contact fault on the internal data link to module F medium
  • Supply dropouts of the battery electronics during switch-on low

Symptoms

  • Hybrid or EV warning, MIL on plug-in hybrids
  • Reduced power output

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U04A6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication