OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U04A4

Invalid Data Received From Particulate Matter Sensor A

Diesel particulate matter (PM) sensors have their own control unit that measures soot on the element and sends the result to the engine controller. GM's 2025 ECM tables (25OBDG04A) check the alive rolling count, protection value and checksum of about twenty soot sensor signals and set U04A4 after 3 bad frames in 10, with battery voltage of at least 11 V for 5 s; it is a Type B code, so the MIL comes on after two trips. VW's 2014 Touareg TDI chart sets it when the sensitivity factor leaves 0.75 to 1.25, when an invalid sensitivity signal lasts 2 s or when sensor messages fail for 0.6 s. Ford's 2014 chart also lists it as a MIL code. U02A3 is total loss, U04B2 the second sensor, U05A4 the reverse direction. The filter monitor pauses until data are valid.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / A4

Possible causes

  • PM sensor control unit or sensing element faulty (heat, soot, moisture) high
  • Replacement sensor of the wrong variant or not yet matched medium
  • Damaged wiring or connector between sensor unit and engine controller medium
  • Low supply voltage disturbing the sensor unit low

Symptoms

  • Check engine light on
  • Particulate filter monitor not completing, readiness missing
  • Usually no change in how the engine runs

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U04A4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication