U04A3
Invalid Data Received From Hybrid/EV Battery Interface Control Module C
U04A3 concerns interface module C. Such boards do more than measure: they also switch the balancing resistors that bleed charge from individual cells. CARB 1968.2 section (e)(15.2.3) requires hybrid OBD to confirm that cell balancing still holds the cell voltages where intended, and GM checks this per board in 16OBDG02 by closing the odd and even balancing gates in turn and comparing readings, for module C under P1E9E. When the battery controller cannot trust what module C sends, it can neither balance nor judge those cells, so it usually limits power. No manufacturer publishes U04A3 itself. U01A2 marks a silent module C, U033C incompatible software; module D's data fault is filed as U02A0, because U04A4 belongs to the particulate sensor.
Possible causes
- Interface control module C faulty (measurement or balancing stage) medium
- Damaged cell sense lead or connector at module C medium
- Interference or contact fault on the pack-internal data link medium
Symptoms
- Hybrid or EV warning, MIL on plug-in hybrids
- Power limited, state of charge shown inaccurately
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U04A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.