OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U04A0

Invalid Data Received From Engine Coolant Pump Control Module

Engines with an electric main coolant pump carry a pump whose built-in electronics set the speed on request and send back status and fault information. Rheinmetall, for example, builds such pumps for main engine cooling with a LIN interface and extensive self-diagnosis, and Hella notes that electric pumps can stay off after a cold start so the engine warms faster. U04A0 means the engine controller still receives pump messages but finds speed, status or check values implausible. No manufacturer documents this code publicly. It matters for emissions because CARB 1968.2 expects coolant temperature to reach its closed-loop threshold in time, which depends on a correctly controlled pump. U019F and U0672 stand for lost contact. Watch the temperature gauge: the engine may run hot, limit power or keep the fan on.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / A0

Possible causes

  • Pump electronics faulty, often after overheating or coolant ingress high
  • LIN or CAN wire or connector at the pump corroded or loose medium
  • Pump running dry or blocked (air in system, debris), reported as error state medium
  • Pump or engine controller software not matched after replacement low

Symptoms

  • Check engine or coolant temperature warning
  • Engine runs hot or the cooling fan runs continuously
  • Reduced engine power to protect the engine

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U04A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication