OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U049E

Invalid Data Received From Direct Ozone Reduction Catalyst Temperature Sensor

Direct ozone reduction (DOR) means a catalytic coating on the radiator, sold by BASF as PremAir, that turns ground-level ozone into oxygen while air flows through the core. CARB grants an emissions credit for it and, under section (e)(14) of 1968.2, wants OBD to watch the coating on cars that claim the credit; a temperature sensor on the radiator serves this purpose. U049E applies where that sensor reports over a data link and its messages arrive but fail plausibility. A hard-wired sensor instead uses P2567 to P2570. No manufacturer documents U049E publicly. U019D marks a sensor that has gone silent. The car drives normally; the result is a MIL, a suspended ozone catalyst check and possibly a failed inspection. Check wiring and the sensor before suspecting the radiator.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 9E

Possible causes

  • Radiator temperature sensor electronics faulty high
  • Damaged connector or wiring near the radiator (impact, corrosion) medium
  • Replacement radiator or sensor not matching the original DOR version medium
  • Sensor or engine controller software version not matching low

Symptoms

  • Check engine light on without noticeable drivability change
  • Emissions inspection failed or readiness not set

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U049E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication