OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U049D

Invalid Data Received From Glow Plug Control Module 2

U049D is logged when a controller, normally the engine control module, still hears from the second glow plug control module but cannot trust what it reports, for instance because a counter, checksum or plug status value is out of line. A second unit is found on diesels that split their glow plugs between two drivers. No manufacturer documents this code publicly; it mirrors U0407, which covers module 1. CARB 1968.2 obliges diesel OBD to verify that glow plugs respond to commands and draw proper current, a check the engine controller can only make with valid module data. A GM patent shows both controllers exchanging timed messages and flagging late ones as faults. U019C means the module is silent, U030B a software mismatch. Hard cold starts and a lit MIL are likely.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 9D

Possible causes

  • Corroded or loose connector or data wire at glow plug module 2 high
  • Supply voltage sagging while the glow plugs draw high current medium
  • Glow plug control module 2 internally faulty medium
  • Module or engine controller software not matched after replacement low

Symptoms

  • Check engine or glow plug warning light on
  • Long cranking or misfire on cold starts
  • White smoke until the engine warms up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U049D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication