U049B
Invalid Data Received From Tachograph Module
U049B is set when the tachograph still transmits but its data are rejected. In trucks and buses EU Regulation 165/2014 has the device record speed, distance and driving times from a motion sensor, and units such as Continental VDO's DTCO 4.1a pass these values on through two CAN interfaces. Engine, transmission or body controllers then rely on the tachograph speed, so implausible frames matter beyond the logbook. Allison's tech tip TT7546EN (2000 and 3000 series, 2014) shows the effect: the calibration tool of a tachograph broadcast a road speed on the data link, the TCM saw speed without output-shaft rotation, stored N/V = 0 and fell back to the performance shift schedule until calibration C142 was flashed. No maker documents U049B publicly; U019A is lost contact.
Possible causes
- Tachograph calibration or parameters not matching the vehicle, e.g. after a tyre or axle change high
- Faulty motion sensor or sensor wiring producing implausible speed values medium
- Internal fault of the tachograph unit low
Symptoms
- Speedometer or tachograph speed missing or erratic
- Cruise control, speed limiter or shift behaviour affected
- Tachograph fault message
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U049B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.